Noob Qn: RDP & RWW – Confgiuring Optus Cable Router with ASA 5505

Home Forums Networking Cisco Security – PIX/ASA/VPN Noob Qn: RDP & RWW – Confgiuring Optus Cable Router with ASA 5505

Viewing 1 post (of 1 total)
  • Author
    Posts

  • woodgrain
    Member
    #163135

    Hi guys,

    I’ve put in place a Cisco ASA 5505 at home to start learning a bit about them, I’m now trying to setup RDP & RWW access to my internal server.

    The layout is this:
    pub internet (say 8.8.8.8 ) -> Optus Router (Cisco DPQ3925-X) 192.168.0.1 -> 192.168.0.99 Out Cisco -> 192.168.1.1 Int Cisco -> Svr 192.168.1.2

    On the Optus DPQ3925-X
    – I’ve gone into: Applications & Gaming – Port Range Forwarding
    – Added port forwards for 43, 3389, 3389 on TCP to 192.168.0.99
    2hrn9ro.jpg

    I’m using ADSM to make the changes.
    I’ve configured the security policy Access Rules like the below picture.
    2vmudxs.jpg

    I’ve read articles that suggest I need to configure NAT, however I only have 1 public IP address so I’m not sure if this is necessary? I’ve followed their steps and have this now set up in NAT:
    2hhemtc.jpg

    When I run the packet tracer I get the following result:
    zmcgmg.jpg

    Assistance would be appreciated – thanks all!

    Cheers!

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.