Cisco 12406 router does not show interface 10g Share on Facebook Post on reddit Tweet on Twitter Share on LinkedIn Home › Forums › Networking › General Networking › Cisco 12406 router does not show interface 10g This topic has 5 replies, 3 voices, and was last updated 5 years, 5 months ago by gmisita. Viewing 1 post (of 1 total) Author Posts monflomaiMember Mar 06, 2015 at 10:10 am #165009 Hello, In the Cisco 12406 router, there is a SIP-601 card, 10 giga ports SPA card and a single card 10Giga #sho diags summary SLOT 0 (RP / LC 0): Modular SPA Interface Card (10G) SUBSLOT 0/0 (SPA-10X1GE-V2): 10-port Gigabit Ethernet Shared Port Adapter SUBSLOT 0/1 (SPA-1X10GE-L-V2): 1-port 10 Gigabit Ethernet Shared Port Adapter XFP based SPA Information: subslot 0/0: SPA-10X1GE-V2 (0x508 ), status is ok subslot 0/1: SPA-1X10GE-L-V2 (0x50C), status is ok When you run the “sho int des” command 10G interface is not displayed, #sho version System image file is “disk0: c12kprp-K4P-mz.120-32.SY10.bin” 2 Route Processor Cards 2 Clock Scheduler Cards 3 Switch Fabric Cards 12 Gigabit Ethernet / IEEE 802.3 interface (s) 1 10GigabitEthernet / IEEE 802.3 interface (s) —- here is The LED “ACTIVE / LINK” is off / off (Port is not enabled by software.) How to turn if the interface is not shown? I would appreciate the help you can give me. Author Posts Viewing 1 post (of 1 total) You must be logged in to reply to this topic.