Trunk on cisco 2650XM 12.3(15b)

Home Forums Networking Cisco Routers & Switches How-to Trunk on cisco 2650XM 12.3(15b)

Viewing 1 post (of 1 total)
  • Author
    Posts
  • Avatar
    king12345
    Member
    #143264

    Hi,

    Im going to made trunk port betwen router and switch, but on the router there is NO switchport command…

    Code:
    Router#conf t
    Enter configuration commands, one per line. End with CNTL/Z.
    Router(config)#interface FastEthernet 0/0
    Router(config-if)#switchport ?
    % Unrecognized command
    Router(config-if)#switchport
    ^
    % Invalid input detected at ‘^’ marker.

    Router(config-if)#

    Code:
    Cisco Internetwork Operating System Software
    IOS ™ C2600 Software (C2600-IS-M), Version 12.3(15b), RELEASE SOFTWARE (fc1)
    Copyright (c) 1986-2005 by cisco Systems, Inc.
    Compiled Thu 25-Aug-05 13:38 by ssearch
    Image text-base: 0x80008098, data-base: 0x81A37EC4

    cisco 2650XM (MPC860P) processor (revision 0x401) with 126976K/4096K bytes of memory.
    Processor board ID FCZ100771G9 (3919692344)
    M860 processor: part number 5, mask 2
    Bridging software.
    X.25 software, Version 3.0.0.
    1 Ethernet/IEEE 802.3 interface(s)
    1 FastEthernet/IEEE 802.3 interface(s)
    32K bytes of non-volatile configuration memory.
    32768K bytes of processor board System flash (Read/Write)

    Slot is empty or does not support clock participate
    WIC slot is empty or does not support clock participate

    Press RETURN to get started!

    Any idea ?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.