pfunckMemberJul 01, 2007 at 9:16 pm #126401
I am trying to enable port security on cisco catalyst 2900 xl:, I have typed command in following order to put fast 0/14 into vlan 5:
1. config t
2. Switch(config)#int fa 0/14
3. switchport access vlan 5
4. switchport mode access
5. switchport port-security ?
% Unrecognized command
6. When I just do switchport ? I only see following options:
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
multi Set characteristics when in multi-VLAN mode
trunk Set trunking characteristics of the interface
Below is the output from sh ver on the switch:
Thank you in advance for reading my post & replying.
Cisco Internetwork Operating System Software
IOS ™ C2900XL Software (C2900XL-HS-M), Version 11.2(8)SA5, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Tue 23-Mar-99 11:44 by rheaton
Image text-base: 0x00003000, data-base: 0x001FAEF8
ROM: Bootstrap program is C2900XL boot loader
Switch uptime is 2 hours, 3 minutes
System restarted by power-on
System image file is “flash:c2900XL-hs-mz-112.8-SA5.bin”, booted via
cisco WS-C2924-XL (PowerPC403GA) processor (revision 0x11) with 8192K/1024K bytes of memory.
Processor board ID 0x0E, with hardware revision 0x01
Last reset from power-on
Processor is running Enterprise Edition Software
24 Ethernet/IEEE 802.3 interface(s)
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 00:D0:58:6D:A0:40
Motherboard assembly number: 73-3382-04
Power supply part number: 34-0834-01
Motherboard serial number: FAA0308A0MB
Power supply serial number: DAB03140DMX
Model revision number: A0
Model number: WS-C2924-XL-EN
System serial number: FAA0319K0G8
Configuration register is 0xF
You must be logged in to reply to this topic.