Natting on a PIX

Home Forums Networking Cisco Security – PIX/ASA/VPN Natting on a PIX

Viewing 1 post (of 1 total)
  • Author
    Posts
  • Avatar
    jay_w
    Member
    #128182

    Hey Guys,

    This is a pretty basic question, but for the life of me, i can’t seem to figure it out. I’m more of a Checkpoint guy, not a pix… so any help would be appreciated.

    I’m trying make a pretty simple NAT… I’m trying to Hide NAT an internal network to a specific IP on the DMZ. So anytime someone comes from ‘inside’ from a subnet, going to the DMZ, all requests will come from that specific IP.

    I’m trying to establish this on a pix version 6.3(4)

    Just an example of what i’m looking for:

    Internal Networks i want to NAT, located on the ‘inside’ interface:
    10.10.0.0/16

    DMZ Network:
    192.168.1.0

    Translated Address i would like to see when any traffic from the above networks go to the DMZ:
    192.168.1.5
    I don’t want this to apply to any other intefaces except for this.

    Any help would be greatly appreciated.

    have a good one!
    thanks!

    -jay

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.