nat & acl – one specific host Share on Facebook Post on reddit Tweet on Twitter Share on LinkedIn Home › Forums › Networking › Cisco Routers & Switches How-to › nat & acl – one specific host This topic has 4 replies, 2 voices, and was last updated 7 years, 5 months ago by Anonymous. Viewing 1 post (of 1 total) Author Posts tehcamelMember Jun 25, 2013 at 10:42 pm #161808 i’ve got the following config for my outbound NAT. ip nat pool RotPool X.Y.Z.A X.Y.Z.B netmask 255.255.255.248 type rotary ip nat inside source route-map nonat pool RotPool access-list 120 permit ip 192.168.X.0 0.0.0.255 any route-map nonat permit 10 match ip address 120 now.. I wish to add an outbound NAT for just a single computer. f I put the following, would it work? access-list 120 deny ip 192.168.x.Y 0.0.0.255 any access-list 130 allow ip 192.168.x.y 0.0.0.255 any access-list 130 deny ip any any ip nat inside source list 130 x.y.z.C (interface within the pool that I want to use) Author Posts Viewing 1 post (of 1 total) You must be logged in to reply to this topic.