InterVLAN routing on Cisco SF300-24PP
- This topic has 1 reply, 2 voices, and was last updated 2 years, 6 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Home › Forums › Networking › Cisco Routers & Switches How-to › InterVLAN routing on Cisco SF300-24PP
Hi,
I’m stuck trying to route between VLANs.
I have a Cisco SF300-24PP set in L3 system mode. I also have an EdgeCore ECS2100-28T L2 switch.
Port 1 on both switch is on VLAN 101 untagged. Port 2 on both switch is on VLAN 102 untagged. The switches are connected on trunk ports.which are tagged members of VLANS 101, 102 and 1 (default).
VLAN101 on the Cisco has address 192.168.1.254.
VLAN102 on the Cisco has address 192.168.2.254.
VLAN1 on the Cisco has address 192.168.98.254.
I can connect a PLC, address 192.168.1.55, on port 1 on the Edgecore switch and ping it from a PC on port 1 on the Cisco switch ok.
I can connect a the same PLC on port 2 on the Edgecore switch and ping it from a PC on port 2 on the Cisco switch ok.
What I need to be able to do is ping [and go online to the PLC] with the PC on port 1 on the Cisco switch and the PLC on port 2 on the Edgecore switch, i.e. between VLANs, and only in that direction..
The PC has address 192.168.1.200/24, gateway 192.168.1.254.
The PLC has address 192.168.2.100/24.
I thought that ACL binding on port 1 or VLAN101 of the Cisco would do the trick for me but I can’t get it to work.
The ACE I was using is attached.
Can anyone help with the routing?
You must be logged in to reply to this topic.
Find out more about our cookie policy here.