Help with 1751-v router and wic-4esw configuration not saving

Home Forums Networking Cisco Routers & Switches How-to Help with 1751-v router and wic-4esw configuration not saving

Viewing 1 post (of 1 total)
  • Author
    Posts
  • Avatar
    Vittorio88
    Member
    #156282

    I have a 1751-v router and wic-4esw 4 ethernet port switch card.
    I am trying to configure the card as a 4 port switch with a single ip address by vlan.

    When configuring the Fastethernet interface, the terminal takes the following comands, but does not save them.

    When I type:
    conf t
    int fa0/1
    switchport mode access
    switchport access vlan 1
    exit
    show run int fa0/1[/CODE]

    I get the interface back with no configuration saved:
    [CODE]interface fastethernet 0/1
    ![/CODE]

    I am running the following release:
    [CODE]c1700-k9o3sv8y7-mz.124-25d[/CODE]

    I am not getting any errors back, the card is properly detected in a show inventory, and I’ve tried a different firmware, a different router, and a different card.

    The only configuration command that “sticks” is shutdown and no shutdown.

    Does anybody know why my configuration is not being saved???
    This is driving me crazy, please help.

    Thanks,
    Vittorio[CODE]conf t
    int fa0/1
    switchport mode access
    switchport access vlan 1
    exit
    show run int fa0/1[/CODE]

    I get the interface back with no configuration saved:
    interface fastethernet 0/1
    ![/CODE]

    I am running the following release:
    [CODE]c1700-k9o3sv8y7-mz.124-25d[/CODE]

    I am not getting any errors back, the card is properly detected in a show inventory, and I’ve tried a different firmware, a different router, and a different card.

    The only configuration command that “sticks” is shutdown and no shutdown.

    Does anybody know why my configuration is not being saved???
    This is driving me crazy, please help.

    Thanks,
    Vittorio[CODE]interface fastethernet 0/1
    ![/CODE]

    I am running the following release:
    c1700-k9o3sv8y7-mz.124-25d[/CODE]

    I am not getting any errors back, the card is properly detected in a show inventory, and I’ve tried a different firmware, a different router, and a different card.

    The only configuration command that “sticks” is shutdown and no shutdown.

    Does anybody know why my configuration is not being saved???
    This is driving me crazy, please help.

    Thanks,
    Vittorio[CODE]c1700-k9o3sv8y7-mz.124-25d[/CODE]

    I am not getting any errors back, the card is properly detected in a show inventory, and I’ve tried a different firmware, a different router, and a different card.

    The only configuration command that “sticks” is shutdown and no shutdown.

    Does anybody know why my configuration is not being saved???
    This is driving me crazy, please help.

    Thanks,
    Vittorio

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.