connection between two vlans on same router

[zaprian]

#154914

hi,
my problem is this:
we have two 2811 router with configured interfaces:
Router1
interface FastEthernet0/0.380
encapsulation dot1Q 380
ip address 192.168.232.18 255.255.255.248
no snmp trap link-status
crypto map clientmap
!
interface FastEthernet0/0.382
encapsulation dot1Q 382
ip address 10.132.1.126 255.255.255.252
no snmp trap link-status

interface Vlan1
ip address 192.168.5.1 255.255.255.128
ip nat inside
ip virtual-reassembly

ip route 0.0.0.0 0.0.0.0 192.168.232.17
ip route 10.132.254.35 255.255.255.255 10.132.1.125

Router2
interface FastEthernet0/0.197
encapsulation dot1Q 197
ip address 192.168.222.2 255.255.255.248
ip nat inside
ip virtual-reassembly
no cdp enable

interface Vlan1
ip address 192.168.1.1 255.255.255.128
ip nat inside
ip virtual-reassembly
ip tcp adjust-mss 1452

ip route 0.0.0.0 0.0.0.0 192.168.222.1

so my case is:computer from router1’s network can ping 192.168.222.2 (router2 -FastEthernet0/0.197 )
computer from router2 network can ping 192.168.232.18 (router1- FastEthernet0/0.380),but can’t ping 10.132.1.126 (router1- FastEthernet0/0.382)
How can i connect vlan 380 and vlan382, so traffic intended to vlan 382 to pass through vlan380. I want the three vlan to see each other.Is this happen with IRB or not?
TNX

[Author]

Posts