Cisco 300 series Help

Home Forums Networking Cisco Routers & Switches How-to Cisco 300 series Help

Viewing 1 post (of 1 total)
  • Author
    Posts
  • Avatar
    paulhugs1
    Member
    #162436

    Hi ALL, im new to Cisco switches. I have been given the task of replacing the existing switches with the Cisco 300,s. I am using them on a cctv system which is transmitting the videos using codecs and wireless ptp bridges. The problem i have is that at certain KEY locations there is currently two or three seperate switches sending the Video(DATA) in two different directions/Locations. Will the switches need to be programmed so the data does not clash. If so which is the best method and how do i go about it. With the existing unmanaged switches i have a data loop occurred when all radios were connected at one end because the data was being sent and received by the same switch.

    ANY HELP/ADVICE WOULD BE GREAT.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.